R
Rigidtalk
Log In
Loading…
Bad Build Review - Rigidtalk
c/bad-build-review
21
c/bad-build-review
•
lisa_hill23
•
18h ago
Vent: dropped $95 on a fancy drawer slide jig for my garage cabinets and it made things worse
0 comments
Share
14
c/bad-build-review
•
robin396
•
8d ago
Vent: my neighbor looked at my new fence gate and said "that latch will outlive the post," and he was right
0 comments
Share
11
c/bad-build-review
•
dakota_butler39
•
9d ago
Spent 9 hours on a 20 minute shelf bracket because I measured off the wrong stud
0 comments
Share
5
c/bad-build-review
•
the_nancy
•
9d ago
I finally pitched my 6 month old shop shelving after one comment from a welder in Dayton
0 comments
Share
30
c/bad-build-review
•
wood.noah
•
9d ago
I rebuilt my garage shelves with 2x4s after the particle board ones sagged an inch in 6 months
0 comments
Share
30
c/bad-build-review
•
the_nancy
•
9d ago
Wasted $180 on a pre-cut plywood shed kit from the hardware place in Waco, wound up framing it myself
0 comments
Share
11
c/bad-build-review
•
caseyl18
•
10d ago
Hot take: I was wrong about bracing my shelf against the drywall, a 12 pack proved it
0 comments
Share
8
c/bad-build-review
•
the_seth
•
10d ago
Figured my dad's old Harbor Freight grinder was junk, then it outlived my 300 dollar one
0 comments
Share
7
c/bad-build-review
•
zarapalmer
•
10d ago
Vent: I called pocket screws a shortcut for 2 years and my shop table just proved me wrong
0 comments
Share
8
c/bad-build-review
•
wyatt_garcia
•
11d ago
My gate sagged 3 inches and I spent 2 whole weekends chasing the wrong fix
1 comments
Share
-1
c/bad-build-review
•
oscarscott
•
17d ago
Dropped $120 on a Harbor Freight benchtop drill press and I can't tell if it saved me or burned me
0 comments
Share
5
c/bad-build-review
•
the_joseph
•
17d ago
My uncle said to slap the wall before drilling for my shelf, and the stud finder was lying to me
0 comments
Share
32
c/bad-build-review
•
faithf77
•
19d ago
Unpopular opinion: my $15 harbor freight clamp gave out mid glue up and taught me more than any youtube tutorial
0 comments
Share
22
c/bad-build-review
•
kelly.keith
•
19d ago
Shoutout to the $22 tube bender that kinked my whole brake line run
0 comments
Share
12
c/bad-build-review
•
simon_lopez35
•
21d ago
Screwing deck boards tight to the joist is the mistake I see on every DIY deck in my neighborhood
1 comments
Share