Why does nobody talk about the plastic intake manifold on the 3.8 V6
My kid's 2004 Mustang started running rough at 112k and I had to pick between a $45 junkyard manifold or a $180 new one with the updated gasket design. I went cheap and it lasted about 9 months before the same coolant leak came back at the seam near cylinder 4. The real problem is Ford molded that coolant crossover right into the plastic, so heat cycling slowly cracks it and there is no fix other than replacing the part. Second time around I paid the $180 and did the thermostat housing at the same time since you are already in there. If you own one of these, watch the coolant level and look for the orange crust under the throttle body. Did anyone else get burned by this, or am I the only one who learned the hard way twice?