I wired 3 attic fans straight to the breaker for 2 years and just now started using a $9 fused switch
I'm posting this because I almost burned a customer's shed down in Baton Rouge last week and it was 100% my own lazy habit. For about 2 years I ran attic exhaust fans straight off the breaker with no switch at all, just wire nutted and taped, because it was quick and the fans were on a dedicated circuit anyway. A buddy who does HVAC work looked at one of my setups and said flat out he would not sign off on that, so I finally switched to a $9 fused disconnect at each fan, mounted on the joist right by the unit. Took me about 20 extra minutes per fan and now when a motor shorts out the fuse pops instead of cooking the wiring in the box. Last week one of those fans seized up and the fuse blew clean, and I could smell it from the hallway without any smoke. If you're still running fans off a bare breaker, go grab a fused switch this weekend, it's cheap insurance. What setup do you all use on attic fans when there's no easy spot to mount a switch?