Why does nobody talk about checking cannon plug pin tension before you start chasing a ghost
Had an intermittent heading flag on a King Air panel swap at our hangar in Peoria and I burned the better part of two shifts swapping the LRU, buzzing harness runs, and re-pinning a connector that turned out fine. The whole time the actual problem was one female contact in a cannon plug that had relaxed just enough to lose grip, maybe 2 or 3 thousandths of squeeze left, so it read good on the meter and broke under any vibration. What I keep seeing guys get wrong is they check continuity and call it done, but continuity tells you nothing about the force holding the pin to the socket. Now I go through every plug on a squawk like that with a cheap pin tension gauge and give each contact a light drag test, takes maybe 10 minutes a connector and it has caught 3 bad pins since spring. The extractor and gauge live in my box now instead of the shop crib, cost me 40 bucks total. Curious what drag spec you all hold to for the smaller contacts, or do you just eyeball it and re-pin if anything feels loose?