Switched from a stud welder to glue pulling for dents last spring

I used to fight with the stud welder on thin panels, burning through and leaving divots every time. After a job on a 2019 Civic door in March, I finally tried the glue pulling kit and the metal barely moved. Has anyone else made that swap and gone back to the welder for certain cases?

1 comments

Log in to join the discussion

Log In

1 Comment

jessica_dixon2mo ago

Glue pulling saved my hands on a 2008 F-150 door last fall, but I went right back to the welder for that one tricky crease by the body line. Glue just won't grab tight enough on sharp, high-tension spots, and I'd rather burn a tiny hole than leave a wave that takes twice as long to fix.

5