My panel gaps went from 4mm to 1.5mm after I switched to a block sander
I spent two years blocking out panels with a DA and always fought waves near the edges. Last month an old timer at the supply counter in Tulsa told me to hand block my primer with a stiff 3M block first, and my gaps tightened up within about three jobs. Curious if anyone else here gave up the DA for the first pass or if I am just late to this.
Blocks have their place but a DA with the right pad and speed will cut flatter than most guys get by hand once you learn it. Going back to a block for the first pass is basically adding a step and slowing yourself down on jobs that pay the same. The waves near edges come from pad tilt and too much pressure, not the tool itself.