Stepper Motor Bracket

From RigidWiki
Jump to: navigation, search

Why Replace Your Rigidbot Stepper Motor Mounts?

I made these because the OEM plastic mount for the X and Y axis were deforming due to the mild tension on the timing belt that was levering them over. This caused the timing belt to twist with every change in direction. They team up nicely with my Linear Bearing Mounts to make a rigid x-gantry. Please note that these mounts are NOT compatible with RB2.

The OEM Rigidbot Stepper Motor Mounts are perfectly adequate for the z-axis where a little bit of flexibility is of benefit. You will note in the picture below that I have added them to my z-axis but with the addition of an Astrosyn Vibration Damper.

Stepper Motor Mount compilation.JPG

They are available on this order form