Filament pinched too tight against the drive gear

helping you get the most out of your RigidBot extruder

Filament pinched too tight against the drive gear

Postby mediathread » 21 Nov 2014, 00:31

I have been trying to test my extruder based on the video. When i ask it to extrude any amount of filament, nothing happens .. If I push down on the head plastic arm just a little, i can see the motor moving and some plastic comes out.

Is there an adjustment for this? I have tried to tighten the screw while i have tension on the spring, but that didn't help..

I am sure its something simple and stupid.

Thanks in advance for any help.
mediathread
 
Posts: 1
Joined: 21 Nov 2014, 00:18

Return to Extruders

Who is online

Users browsing this forum: No registered users and 1 guest
cron