problems with V6 and glow in dark PLA

helping you get the most out of your RigidBot extruder

problems with V6 and glow in dark PLA

Postby jackneeson » 17 Jul 2018, 10:53


I've just replaced the stock hot end on my rigidbot with a V6. It printed in ABS very nicely with no jams, but it always jams when I'm trying to print in glow-in-the-dark PLA. I've tried adjusting the temperature, bringing the retraction rate down to 0.8, and even tried feeding the filament through a sponge soaked in canola oil. What else can I try to fix this? Is it possible that the glow in the dark PLA is too think or not smooth enough? It has a different texture to normal PLA.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References: ... k-pla.259/
Product Video Service

Thank you.
Posts: 8
Joined: 04 Jun 2018, 09:51

Return to Extruders

Who is online

Users browsing this forum: No registered users and 2 guests