Extruder Temp Swings

helping you get the most out of your RigidBot extruder

Re: Extruder Temp Swings

Postby acucci » 25 Sep 2014, 14:04

I'm having the same problem. Recently broke down the extruder head to clear the PTFE tube and reassembled. Now it will not hold temp, swings +/- 7-8 degrees. I ran autotune and uploaded the new PID values (13.11 0.59 72.81) to no effect. Any other suggestions?
Posts: 6
Joined: 31 Jul 2014, 17:41

Re: Extruder Temp Swings

Postby spiderdaddy » 28 Sep 2014, 22:42

1. Did you save the values with M500?
2. Try autotuning again after setting those values, can be an iterative process.
3. Check the resistances of the heater and the thermistor.
User avatar
Posts: 125
Joined: 04 May 2014, 19:51


Return to Extruders

Who is online

Users browsing this forum: No registered users and 1 guest