Question On Morningstar Solar Controller Output To Battery

Troubleshooting for the mechanical elements of the RigidBot

Question On Morningstar Solar Controller Output To Battery

Postby MichaelSmith » 19 May 2018, 03:41


Finally got a solar panel (95 watt) and rigged a power wire with the 3-wire male solar plug supplied with the CI 550 Ultra. Put the panel out in the sun and plugged it in. The meter read 17.1 volts and 4.47 amps. This seemed like straight uncontrolled solar panel output. I was worried that the high voltage would cook my AGM battery so unhooked the panel right away.
According to the data sheet, the solar controller should be putting out something around 14.1 volts. What volt readings are typical when the Morningstar SunSaver SS-10-12V is charging from a solar panel?

Any help will be apprecited.
I didn't find the right solution from the Internet.

References: ... tery.4385/
Best video production service

Thank you
Posts: 12
Joined: 09 May 2018, 10:25

Return to Mechanical

Who is online

Users browsing this forum: No registered users and 2 guests