MECHANICAL ERROR 02 WITH SHINKO S2145?

Troubleshooting for the mechanical elements of the RigidBot

MECHANICAL ERROR 02 WITH SHINKO S2145?

Postby MichaelSmith » 10 May 2018, 06:16

Hello,

I has any one had this error appear on the lcd of this printer and if so how was it fixed.I was able to open the pritner by using a screw driver through the vent holes. moved the little cutter wheel over to the left with same screwdriver and the error was cleared for a bout a minute till I restared it...the fact that the printer requires electricity to open it up.

Please help.

I didn't find the right solution from the Internet.

References:-
http://www.photoboothtalk.com/forum/vie ... ?f=6&t=778
Explainer video agency

Thanks
MichaelSmith
 
Posts: 12
Joined: 09 May 2018, 10:25

Return to Mechanical

Who is online

Users browsing this forum: No registered users and 1 guest
cron